Primary clutch assembly/ 2x9.8mm pin/ 6x8x0.5 TW (1)
Servo horn, steering/ linkage, steering (3x30 threaded rod)/ rod ends (2)/ hollow balls (2)
Turnbuckles, Camber Link, 49mm (73mm Center to Center) (assembled with Rod Ends and Hollow Balls) (1 Left, 1 Right)
Differential output yokes (heavy duty) (2)/ set screw yoke pins, M4/10 (2)
Cover plates and seals, forward only conversion (Revo®) (Optidrive® blank-out plate, Optidrive® sensor cover, shift fork cover) These seals cover a...
View full details
Clutch bell, (18-tooth)/ 5x8x0.5mm fiber washer (2)/ 5mm E-clip (requires #4609 - ball bearings, 5x10x4mm (2))
Clutch bell, (16-tooth)/5x8x0.5mm fiber washer (2)/ 5mm E-clip (requires #2728 - ball bearings, 5x8x2.5mm (2)
Spur gear, 58-tooth (0.8 metric pitch, compatible with 32-pitch)
Spur gear, 54-tooth (0.8 metric pitch, compatible with 32-pitch)
Spring retainers, upper & lower (2)/ piston head set (2-hole (2)/ 3-hole (2))
Wheelie bar, assembled (black) (fits Slash®, Stampede®, Rustler®, Bandit® series)
Sold out
Turnbuckles, camber link, 39mm (69mm center to center) (assembled with rod ends and hollow balls) (1 left, 1 right)
Mounts, suspension arm (rear) (+/- 1-degree) (L&R) (gray)
Turnbuckles, toe link, 55mm (75mm center to center) (2) (assembled with rod ends and hollow balls)
Half shafts, long truck (external-splined (2) & internal-splined (2)/ metal U-joints (4)
Wheel hubs, 12mm hex (blue-anodized, lightweight aluminum) (2)/ axle pins (2)
This item was acquired from a collector. The engine has been tested. The original box is in excellent shape. Please see photos for detail. This is...
View full details
This item was acquired from a collector. It has been tested and it runs well. It is in the original box. The box shows slight shelf wear. Please se...
View full details
This item was acquired from a collector. It has been tested and it runs well. It does not have its original box. The box it is in shows moderate sh...
View full details
