All

This Maine Central caboose with Bettendorf Swing Motion trucks was built in the early 1940s and painted in the yellow/green “Think Safety, Work Saf...

This 100-ton gondola with Barber Roller Bearing trucks was built in late 1970, and in 1978, converted into a covered coil car at the Coster Shops. ...

This 100-ton gondola with Barber Roller Bearing trucks was built in late 1970, and in 1978, converted into a covered coil car at the Coster Shops. ...

This HTx-Class 2-bay coal hopper with Bettendorf trucks was built in the late 1950s and continued in revenue use through the 1970s. Reading can be ...

This HTx-Class 2-bay coal hopper with Bettendorf trucks was built in the late 1950s and continued in revenue use through the 1970s. Reading can be ...

Pullman-Standard built over one million freight cars and decorated several over the years commemorating various milestones. This 50’ boxcar with Ba...

This high-quality polycarbonate BIG ROCK 6S pre-painted bodyshell is the perfect replacement for your kit item. Features Strong and flexible po...

Losi 8IGHT-X 4X4 Super Lasernut 1/6 Scale Buggy Overview Ultra4 racing is a unique mix of off-road motorsports. There are challenging rock trails t...

Features Incredible deep-V styling and performance Proven self-righting capabilities Completely ready-to-run with Spektrum Smart...

Toe links, Revo® (TUBES red-anodized, 7075-T6 aluminum, stronger than titanium) (128mm, fits front or rear) (2)/ rod ends, rear (4)/ rod ends, fron...

Servo horns, steering and throttle (for non-Traxxa®s servos (Hitec, JR, KO, Airtronics))

Wheel hubs, splined, 17mm (blue-anodized) (4)/ wheel nuts, splined, 17mm (blue-anodized) (4)/ screw pins, 4x13mm (with threadlock) (4)

Fuel tank (complete)

Pull ring (2), fuel tank cap (1)/ engine shut-off clamp (1)

Output shaft, transmission

Spool, differential (eliminates differential. Use off-road only) (requires #5379X ring gear)

Gear set, 2-speed close ratio (2nd speed gear 40T, 13T-16T input gears, hardware)

Gear set, 2-speed wide ratio (2nd speed gear 38T, 13T-18T input gears, hardware)

Gear, 1st speed, 43T

Body, Revo® 3.3, ProGraphix® (replacement for painted body. Graphics are printed, requires paint & final color application)/decal sheet

Primary clutch assembly/ 2x9.8mm pin/ 6x8x0.5 TW (1)