TRAXXAS

Suspension screw pin set, steel (hex drive) (requires part #2640 for a complete suspension pin set) (Bandit®, Rustler®, Stampede®)

Unleash Maximum Power with the 3956R Spur GearExperience the thrill of high-speed racing like never before with the 3956R Spur Gear. Specially engi...

Air filter (foam insert only)

Brake disc/ shaft-to-disc adapter

Optimize Your Ride with Precision AdjustmentThe 4338 Adjustment Spacers for 4-Tec vehicles offer unbeatable precision for the ultimate driving expe...

Ball bearings (5x11x4mm) (2)

Ultimate Precision for Every ProjectUpgrade your toolkit with the 4871 Screws 3x36mm Hex Nitro 4-Tec 3.3, a game-changer for hobbyists and professi...

Unleash Superior Performance with 4918 Servo MountsElevate your T-Maxx to new heights of precision and reliability with the 4918 Servo Mounts Front...

Box, receiver/ x-tal access rubber plug/ adhesive foam chassis pad

Enhance Your Vehicle's Appearance with Sleek DesignUpgrade your ride with the sophisticated 4930R Bulkheads L&R Front Gray. These bulkheads are...

Brake disc

Brake pads (2)/ brake piston/ 3x15mm cap hex screws (2)

Overview Revo's linkage-based suspenciosn requires different push rod assmeblies depending upon which rockers are used, Strong, 7075-T6 aluminum ve...

Hold down bracket, electronic speed control (Castle Creations Mamba Monster brushless system)

Hold down, battery/ hold down retainer/ battery post/ angled body clip (allows for installation of taller, multi-cell batteries)

Ball bearings, blue rubber sealed (4x8x3mm) (2)

Driveshaft assembly (1) left or right (1/16 Slash) (fully assembled, ready to install)/ 3x10mm screw pin (1)

Servo horn, steering/ linkage, steering (46mm, assembled with pivot balls)

Rebuild kit, slipper clutch (steel disc/friction insert (1)/spring (1)/2.5x12mm pin/4.0mm NL(1))

Enhanced Stability and PrecisionTransform your 4-Tec driving experience with the 4330 Lower Suspension Mount 3 Degree. Specifically engineered to o...

Ball bearing (1)(10x19x5mm)

Pulleys, 20-groove (middle) (2)/flanges (2)/ axle pins (2)

Gear shaft, primary (1)

Mounts, suspension pin (rear anti-squat blocks) (1.5, 2.25, 3.0 & 3.75 degree) (1 each)