Under $50

This N6B-class caboose with Bettendorf trucks was built in 1922 and served the Philadelphia Region. It was repainted into the Keystone scheme with ...

This BC-50-2-class 50’ boxcar with Bettendorf trucks was one of 500 built at the Union Pacific Omaha shops in 1956. Union Pacific continues to oper...

This Maine Central caboose with Bettendorf Swing Motion trucks was built in the early 1940s and painted in the yellow/green “Think Safety, Work Saf...

This 100-ton gondola with Barber Roller Bearing trucks was built in late 1970, and in 1978, converted into a covered coil car at the Coster Shops. ...

This 100-ton gondola with Barber Roller Bearing trucks was built in late 1970, and in 1978, converted into a covered coil car at the Coster Shops. ...

This HTx-Class 2-bay coal hopper with Bettendorf trucks was built in the late 1950s and continued in revenue use through the 1970s. Reading can be ...

This HTx-Class 2-bay coal hopper with Bettendorf trucks was built in the late 1950s and continued in revenue use through the 1970s. Reading can be ...

Pullman-Standard built over one million freight cars and decorated several over the years commemorating various milestones. This 50’ boxcar with Ba...

Toe links, Revo® (TUBES red-anodized, 7075-T6 aluminum, stronger than titanium) (128mm, fits front or rear) (2)/ rod ends, rear (4)/ rod ends, fron...

Servo horns, steering and throttle (for non-Traxxa®s servos (Hitec, JR, KO, Airtronics))

Wheel hubs, splined, 17mm (blue-anodized) (4)/ wheel nuts, splined, 17mm (blue-anodized) (4)/ screw pins, 4x13mm (with threadlock) (4)

Fuel tank (complete)

Pull ring (2), fuel tank cap (1)/ engine shut-off clamp (1)

Output shaft, transmission

Spool, differential (eliminates differential. Use off-road only) (requires #5379X ring gear)

Gear set, 2-speed close ratio (2nd speed gear 40T, 13T-16T input gears, hardware)

Gear set, 2-speed wide ratio (2nd speed gear 38T, 13T-18T input gears, hardware)

Gear, 1st speed, 43T

Body, Revo® 3.3, ProGraphix® (replacement for painted body. Graphics are printed, requires paint & final color application)/decal sheet

Primary clutch assembly/ 2x9.8mm pin/ 6x8x0.5 TW (1)

Wing mount, center / wing washers (for Revo®)