traxxas

Sway bars (front) (includes soft, medium, hard)

Seal kit, receiver box (includes o-ring, seals, and siliconee grease)

Hold down bracket, electronic speed control (Castle Creations Mamba Monster brushless system)

Door, battery compartment (2) (fits right or left side)

Skidplate, transmission, nylon (black)/ cover

Gear, 20-T pinion (0.8 metric pitch, compatible with 32-pitch) (fits 5mm shaft)/ set screw

Gear, 27-T pinion (0.8 metric pitch, compatible with 32-pitch) (fits 5mm shaft)/ set screw

Half shafts, center (internal splined (3)/ external splined (2)) (plastic parts only)

Differential CV output drive (machined steel) (1)/ screw pin (with threadlock) (1)/ cross pin (1)/ drive pin (1)/ set screw (1)

Stub axle, CV style (machined steel) (1)/ cross pin (1)/ drive pin (1)

Half shaft set, short (plastic parts only) (internal splined half shaft/ external splined half shaft/ rubber boot) (assembled with glued boot) (2 a...

Half shaft set, long (plastic parts only) (internal splined half shaft/ external splined half shaft/ rubber boot) (assembled with glued boot) (2 as...

Cover, gear/ 3x8mm CS (1)

Plate, motor (for single motor installation, use with gear cover #5677R)

Drive strut

Propeller shaft/ flex cable, DCB M41 (380.9mm)

Stuffing tube (assembled with liner)

Rudder (127.5 mm)/ rudder arm/ hinge pin/ 3x15mm BCS (stainless) (2)/ NL 3.0 (2)/ 4x3mm BCS (stainless, with threadlock) (1)

Rudder mount/ rudder pivot/ 4x14mm BCS (stainless) (4)/ NL 4.0 (2)

Rudder pushrod, assembled/ servo horn/ 3x18mm BCS (stainless) (1)/ 3x15mm CS (stainless) (1)/ 3x6mm CS (stainless) (1)/ NL 3.0 (1)

Motor mount/ flex cable guard, DCB M41

Alignment tool, drive strut, DCB M41

Body accessories kit, 2017 Ford Raptor® (includes grille, hood insert, side mirrors, & mounting hardware)

Chassis, low CG (black)