TRAXXAS

Screw, idle speed/ 2x1mm O-ring (1-each) (TRX® 2.5, 2.5R, 3.3)

Dust boot, throttle (2)/ return spring (TRX® 2.5, 2.5R, 3.3)

Flywheel nut (TRX® 2.5, 2.5R, 3.3)

Pipe coupler, molded (blue)/ exhaust deflecter (rubber, blue)/ cable ties, long (2)/ cable ties, short (2)

Pipe coupler, molded (black)/ exhaust deflecter (rubber, black)/ cable ties, long (2)/ cable ties, short (2)

Pipe coupler, molded (for use with pipes 5152 (T-Maxx®) & 4452R) (TRX® 2.5, 2.5R, 3.3)

Needle assembly, high-speed (with fuel fitting)/ 2.5x1.15mm O-ring (2)/ 5.3x7.8x.6mm crush washer (2) (TRX® 2.5, 2.5R, 3.3)

Needle, low-speed/ 2x1mm O-ring (2) (TRX® 2.5, 2.5R, 3.3)

Header spring/ gaskets (TRX® 2.5, 2.5R, 3.3)

O-ring, header 12.2x1mm (TRX® 2.5, 2.5R, 3.3)

Air filter body (high volume)/ filter support/ cap/ foam filter, pre-filter/ air filter base/ wire mount/ hardware (1 each)

Backplate/ 20x1.4mm O-ring (for engines with starter) (TRX® 2.5, 2.5R, 3.3)

Header, blue-anodized aluminum (for rear exhaust engines only) (TRX® 2.5, 2.5R, 3.3)

Wrist pin (1), Wrist Pin Clips(2) (TRX® 3.3)

Guards, steering servo (2)

Roll hoop, plastic/ transmission skid guard, plastic

Overview Revo's linkage-based suspenciosn requires different push rod assmeblies depending upon which rockers are used, Strong, 7075-T6 aluminum ve...

Push rod (steel) (assembled with rod ends) (2) (black) (use with #5359 progressive 3 rockers)

Push rod (aluminum) (assembled with rod ends) (2) (red) (use with #5359 progressive 3 rockers)

Suspension pin set (front or rear, hardened steel), 3x20mm (4), 3x40mm (2))

Bulkhead tie bars, front & rear (blue-anodized aluminum)